Tags: custom made laces shoeslace, boy printed shoeslace, laces for shoeslace, Factory batch shoelaces,
1.Put the ends of the laces into the holes closest to your toe. Remove the laces from your shoe. Put both ends of the lace in the bottom holes going from the outside to the inside. This should create a bar across the bottom two holes on the outside of the shoe. Pull the ends of the lace up to tighten it. Make sure the lace is centered and that both ends are the same length.
2.Make your first "bar" by bringing the left shoelace up and across to the right. Bring the left shoelace up through the second hole from the bottom. This should be the hole just above the hole it went into. Then bring the lace across and push it down through the hole straight across from it. This should make a bar across the front of the shoe on the outside.
3.Make your second "bar" by bringing the right shoelace up and across to the left. Bring the right shoelace up through the third hole from the bottom. This should be the hole just above the hole the left lace went into. You will then thread the right lace down through the hole immediately across from it, the same as you did with the left end. This should make the second bar.
4.Continue making "bars" up the front of the shoe. Continue to thread the laces according to this pattern: bring the left lace up through the hole just above the previous hole you worked with, and down into the hole straight across. Then bring the right lace up out of the hole just above the hole the left lace went into, and bring the right lace down into the hole straight across.
.On the underside, your laces should run alongside the tongue of the shoe without crossing it
5.Tie a bow on the inside of the shoe. Make a bow as you normally would, but hide it under the tongue of the shoe. Cross the left lace over the right lace, and bring it down to twist the laces. Now make a loop with the right lace, and wrap the left lace around the back of the loop, bring it forward, and push it through the hole under the loop. Grab the original loop and the loop you have just made, and pull them until the bow is tight.
.Some people find having the bow under the tongue makes their shoes painful to wear. If this is uncomfortable for you, you can try pushing the bow under the sole of the shoe or to one side of your foot instead.
Dongguan Hengfeng Weaving Co., Ltd.
Contact information:
Tel: +8618565366319 , +8613712255719 , +86076989763060,
Email: dglxsl@163.com , eddyzhang@hf-shoelaces.com
Website: www.shoelacesonly.com, www.shoecord.com
