About The Magic Laces - How to Tie The Magic Shoelaces

•	Magic Shoelaces

•	Regular Shoelaces

•	Heat Transfer Shoelaces

•	Shoelace Displays

•	Cell Phone Straps

•	Lanyards

Learn our No-Slip shoelace tying method

Flower Design:

Insert tip into hole as shown.
Insert same tip back into loop in the other direction. Skip 2 holes and insert tip again.
Repeat Step #2 several times.
Repeat Step #2 until 10 small loops are formed.
Finish by pulling ends tightly to form a circular flower design.

*Note: The location of design should be the middle. Start from the middle and count down the number of holes necessary to determine the starting point. Also, keep lace straight and flat while attempting designs (do not twist).

Zigzag Design:

Insert tip in and out of 2 consecutive holes as shown.
Skip 4 holes. Insert tip in and out of 2 consecutive holes.
Repeat Step #2 twice.
Insert other tip into loops in the opposite direction. Follow by inserting tip in and out of 2 consecutive holes in the large loop as shown.
Finish by pulling both ends tightly in opposite directions.

Crown Design:

Insert tip in and out of 2 consecutive holes as shown.
Skip 4 holes. Insert tip in and out of 2 consecutive holes.
Repeat Step #2 three times. Insert other tip into loops in the opposite direction.
After the last hole, insert tip into the large loop. Skip 2 holes and insert again.
Finish by pulling both ends tightly in opposite directions.

Leaf Design:

Insert tip into hole as shown.
Insert same tip back into loop using next hold. Skip 2 holes and insert back out of the loop.
Insert tip back into loop using next hole. Skip 3 holes and insert back out of the loop .
Repeat Step #2.
Finish by pulling tip until tightened.

Egg Design:

Insert tip into hole as shown.
Insert same tip back into loop using next hold. Skip 2 holes and insert tip again.
Repeat Step #2 three times. Insert other tip into loops in the opposite direction.
After the last hole, insert tip in and out of 2 consecutive holes in the large loop.
Finish by pulling tip until tightened.

Loop Design:

Insert tip into hole as shown.
Form a loop and insert same tip into hole just below the large loop.
Pull tip until both ends are parallel and similar in length as shown.

*Note: Keep lace straight and flat while attempting design (do not twist).

Banana Design:

Insert tip into hole as shown.
Insert same tip back into loop in the other direction. Skip 2 holes and insert back out of the loop.
Insert tip back into loop using next hole. Skip 3 holes and insert back out of the loop .
Insert tip back into loop using next hole. Skip 4 holes and insert tip.
Finish by pulling tip until tightened.

Bow Design:

Insert tip into hole as shown.
Skip 5 holes and insert tip again.
Insert other tip into hole just below the small loop. Pull the end to form another loop .

*Note: Keep lace straight and flat while attempting designs (do not twist).

All Designs

Click on each image to enlarge.

Trutex, Inc. is a rapidly growing footwear and shoelaces manufacturer and supplier conveniently located in Los Angeles County. We have a growing number of satisfied clients from all over the continental US. Our shoelace products represent innovative and unique ideas stemming from the combined experience of our creative team. The head controller alone has over 40 years of experience in the footwear and shoelaces industry.